Marushin UZI...

To be played at Maximum Volume... Go On... Right Up...




8Ace's steel bolt transformed this into a gun that WORKS...

Thanks 8Ace,

Cerwyn


Refer http://mp40modelguns.forumotion.net/modelgun-videos-f2/marushin-uzi-t62.htm#9160 for continuing discussion...

Posted by Mark


I think that this was at least 20~25 rounds fired in succession. These where old somewhat beat up cartridges and no other preparation other than a clean gun, tight lower bolt assy, tight detonator and grease in the cartridges. I was using the MGC 7mm caps (one per cartridge) I ensured that the cartridge(s) rims where screwed on tight before loading them into the magazine. This is an all stock late model Marushin Uzi with the aluminum receiver using the original detonator as well as the stock un-cut recoil spring as well..

So, without further ado..



I also held the gun rather tightly to my shoulder and griped it tightly as well. whether or not that helped it ripped off all of those rounds all the same..


Refer to http://mp40modelguns.forumotion.net/modelgun-videos-f2/late-marushin-uzi-firing-marushin-mp40-uzi-cartridges-posted-by-mark-t25.htm

Discussions following the posting of this video have identified this as a Gas Blow Back Airsoft model, not PFC...
For more info please see http://mp40modelguns.forumotion.net/gbb-airsoft-general-discussion-f38/marushin-uzi-new-video-t1786.htm Cerwyn 22/10/09



Not sure why this modelgun sounds so quiet, other Marushin UZIs as well as my own makes louder bangs than this. Could be the video camera perhaps.
There's no doubt that this one fires beautifully though... not a single miss nor jam... lovely