MP40's Modelguns Forum

International Forum for Modelgun enthusiasts
 
HomeFAQRegisterLog in

Share | 
 

 How to get this out?

Go down 
AuthorMessage
lacki5night@gmail.com
New Member
New Member


Number of posts : 2
Location / Country : Deutschland
Registration date : 2016-05-20

PostSubject: How to get this out?   Sun May 22, 2016 10:31 am

Back to top Go down
View user profile
8ace
Modelgun Perfectionist
Modelgun Perfectionist
avatar

Number of posts : 2388
Location / Country : UK
Registration date : 2008-08-06

PostSubject: Re: How to get this out?   Sun May 22, 2016 2:24 pm

Hi,

If the cap has been fired then I use a pin punch and gently tap it through from the back.

Hope this helps

8ace
Back to top Go down
View user profile
smootik
Modelgun Perfectionist
Modelgun Perfectionist
avatar

Number of posts : 1786
Location / Country : Poland
Registration date : 2009-03-03

PostSubject: Re: How to get this out?   Sun May 22, 2016 10:11 pm

If not fired, I use a needle to gently pry it out.
Making sure all the time that the thing points in SAFE direction!!!! Always looking from a side.

Sometimes it gets sucked in due to grease/silicon seal, things get tricky then...
Back to top Go down
View user profile
Sponsored content




PostSubject: Re: How to get this out?   

Back to top Go down
 
How to get this out?
Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
MP40's Modelguns Forum :: Modelgun General Discussion-
Jump to: