MAC-11 Take Down Instructions

I am building a MAC-11 from a KWA airsoft GBB and a G&P steal conversion kit which did not come with instructions.

I have cold blued the upper and lower receiver.

I am having problems with the take down of the original plastic MAC, such as removing the pins and rear stock floor plate.


Where can I find instructions (English please) online? The kit does not come with any.

The interior is very similar to a real MAC so a PFC guide would help as well.


Edit: see also https://mp40modelguns.forumotion.net/modelgun-instructions-f10/mgc-mac-11-t101.htm for full PFC Instruction manuals

MGC MAC11 exploded diagram, hope it helps:

The diagrams help since they’re very similar to a real MAC, but my key problems are removing the pin #42 and locking springs, #52, #58, #60, and #60. How do I get #42 out?

As well as #65?

You need to remove the tension from where spring #58 meets pin #42.

You can do this either by lifting the end of spring #58 ( on the left of the drawing ) out of the little channel it sits in or by lifting the other end ( right hand on the drawing ) and pushing out the fire select lever.

Both of these will remove the tension on pin #42 and it can be withdrawn.

re fitting is the reverse ( I usually hook the left side over last )

#65 knock it out with a drift or pin of just under the same size

DOC

Does this help anyone

https://youtu.be/jtAonGTLTXU