MP40's Modelguns Forum

International Forum for Modelgun enthusiasts
 
HomeFAQRegisterLog in

Share | 
 

 WTB MGC68 MP40 parts

View previous topic View next topic Go down 
AuthorMessage
Chris Rush
New Member
New Member


Number of posts : 53
Age : 68
Location / Country : 19352 Pennsylvania United States
Registration date : 2015-03-07

PostSubject: WTB MGC68 MP40 parts   Sun Aug 21, 2016 7:35 am

Hello guys, recently, I received an email from a pal asking if I'd be interested in buying an MGC68 MP40 and an accompanying parts gun. Need I say more? If the complete MP40 works as good as it looks, I'll be very, very happy. The parts gun was advertised as such so I can't complain.

Forum member DOC initially posted a four page MGC MGC68 MP40 instruction sheet but; the instruction material wasn't quite complete. Part #42 is a round, heavy, metal piece that sits at the rear of the lower receiver. A flat piece of thin metal (part # unknown) is shaped something like the letter "W". It has a pin or screw in the center. This piece sits inside the round cup (part#42). I believe that the "plunger system" is stabilized at one end by it's installation into the bolt and the tapered end section is seated on this missing part.

If anyone is able to follow the above perhaps, I'll find out what the part is called. If an extra whatever it is happens to be laying around anyone's house please get in touch. Will pay any reasonable price.
Many Thanks, Chris
Back to top Go down
View user profile
philb
New Member
New Member


Number of posts : 40
Location / Country : Anglia
Registration date : 2016-01-31

PostSubject: Re: WTB MGC68 MP40 parts   Sun Aug 21, 2016 7:54 am

Back to top Go down
View user profile
Chris Rush
New Member
New Member


Number of posts : 53
Age : 68
Location / Country : 19352 Pennsylvania United States
Registration date : 2015-03-07

PostSubject: Thanks Philb,   Sun Aug 21, 2016 8:01 pm

Philb, thanks for the input, I thought that I had scoured everything relating to the MGC68 MP40. As you've indicated, there must be a great many gun variations. The C shaped clamp shown differs from the one in my complete MP40. I suspect that either one of the clamps would be interchangeable. Now to find a replacement. Thanks again, Chris
Back to top Go down
View user profile
Sponsored content




PostSubject: Re: WTB MGC68 MP40 parts   

Back to top Go down
 
WTB MGC68 MP40 parts
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Parts washer fluid
» Parts List for the Conversion
» best sites to find parts for ae82 sadans
» Public Service Message - BFY parts
» Chevy Van PARTS & INTERCHANGE

Permissions in this forum:You cannot reply to topics in this forum
MP40's Modelguns Forum :: Buy / Sell Modelguns/ Parts / Cartridges-
Jump to: