Cerwyn
Cerwyn (Site Admin)
Number of posts : 11090
Age : 65
Location / Country : North Wales
Registration date : 2008-07-20
 | Subject: Marushin UZI ... Basic Strip Down Guide  Mon Sep 29, 2008 10:58 am | |
| Basic Strip Down... Marushin UZI***UNDER CONSTRUCTION...UPDATED PHOTOS TO FOLLOW***When I bought my first model gun I had no idea how to strip it down for cleaning and inspection. On-line help from forum members here got me sorted so I thought it might be a good idea to post up a Step by Step guide for Beginners.
The Marushin UZI is relatively easy strip, dismantle and maintain. Just like its real life counterpart, it was designed to be a solid and reliable weapon capable of being taken apart and maintained by a soldier in the field with the minimum of tools.
Cleaning, Inspection of components and Re-assembly will be covered in separate Step by Step Guides so this guide begins with your UZI in need of dismantling after firing.Step 1. Magazine Removal
Push the magazine catch, withdraw the magazine...Step 2. Remove Top PlateFirst make sure the Bolt is fully forward.
Push this spring loaded catch back
...and lift the top plate upStep 3. Removing the Bolt Carrier, Recoil Spring & Guide RodPull the Bolt Carrier back against the Recoil Spring's pressure and lift the assembly up and out of the Receiver.
Be Warned that the Recoil Spring is strong and as the UZI is an all metal model there is every chance you''ll get your fingers pinched if the Bolt snaps forwards (I speak from experience... it hurts too!)The Bolt, Recoil Spring & Guide...Step 4. Removing Bolt from Carrier This socket head screw locks the Bolt to the carrier
Simply unscrew this, push the bolt to unhook it's "clip" and pull it freeStep 5. Removing Detonator Chamber Assembly
Removing the top plate by unscrewing these 2 cross head screws detaches the chamber from the Receiver Pull the Chamber assembly away from the Lower ReceiverStep 6. Removing Detonator PinUnscrew this cross head screw,
...push the Detonator Pin out and clear. The Pin can get very dirty and clogged up with deposits. It can stick inside the chamber and may need some persuasion to remove.Step 7. Removing Trigger and Mag Well AssemblyRemove this Screw...
Push out the Retaining Pin
Push the Grip Safety switch inwards, and tilt the Grip assembly up and away from the rear of the receiver
The Grip Assembly has a locating peg that slots into the Receiver, don't force the assembly clear as this could snap offStep 8. Removing the BarrelGrasp the Barrel Retaining Ring, push inwards, towards the receiver, then unscrew until the barrel and ring pull clear.Your UZI is now stripped ready for cleaning, inspection and re-assembly...
Ref: http://www.mp40modelguns.com/forum2/viewtopic.php?t=2386 Basic Strip Down
Ref: http://www.mp40modelguns.com/forum2/viewtopic.php?t=2387 Basic Reassembly
Ref: http://www.mp40modelguns.com/forum2/viewtopic.php?t=2264 Loading Marushin 9mm Cartridges
Ref:http://www.mp40modelguns.com/forum2/viewtopic.php?t=2266 Loading MGC c.p. type Cartridges
Ref:http://www.mp40modelguns.com/forum2/viewtopic.php?t=2390 Basic Parts Inspection GuideCerwyn
Last edited by Cerwyn on Tue Aug 22, 2017 4:16 pm; edited 4 times in total (Reason for editing : images converted to servimg) | |
|
