MP40's Modelguns Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.
MP40's Modelguns Forum

International Forum for Modelgun enthusiasts
 
HomeLatest imagesRegisterLog in

 

 mac 11 hex screw won't fit barrel anymore

Go down 
3 posters
AuthorMessage
trevinator13
New Member
New Member



Number of posts : 33
Location / Country : USA
Registration date : 2009-04-15

mac 11 hex screw won't fit barrel anymore Empty
PostSubject: mac 11 hex screw won't fit barrel anymore   mac 11 hex screw won't fit barrel anymore Icon_minitimeFri May 17, 2013 12:37 pm

Hi everyone--any solutions for this? My hex screw won't fit in the barrel of the MAC 11 anymore--probably too much jostling around over time, caused the hole to stretch out. Thanks in advance-
Back to top Go down
smootik
Modelgun Perfectionist
Modelgun Perfectionist
smootik


Number of posts : 1823
Location / Country : Poland
Registration date : 2009-03-03

mac 11 hex screw won't fit barrel anymore Empty
PostSubject: Re: mac 11 hex screw won't fit barrel anymore   mac 11 hex screw won't fit barrel anymore Icon_minitimeFri May 17, 2013 5:51 pm

I think I used bits of plumber's teflon tape to reduce hole size (and not damage screw/barrel more).
It sort of worked, not perfect, just good enough as a temporary fix.
Back to top Go down
8ace
Modelgun Perfectionist
Modelgun Perfectionist
8ace


Number of posts : 2560
Location / Country : UK
Registration date : 2008-08-06

mac 11 hex screw won't fit barrel anymore Empty
PostSubject: Re: mac 11 hex screw won't fit barrel anymore   mac 11 hex screw won't fit barrel anymore Icon_minitimeFri May 17, 2013 5:59 pm

Hiya,

If its the one for the det pin, I have re-tapped the thread to an M4 and put in a new screw.

8ace


Last edited by 8ace on Sat May 18, 2013 6:29 am; edited 1 time in total
Back to top Go down
trevinator13
New Member
New Member



Number of posts : 33
Location / Country : USA
Registration date : 2009-04-15

mac 11 hex screw won't fit barrel anymore Empty
PostSubject: Re: mac 11 hex screw won't fit barrel anymore   mac 11 hex screw won't fit barrel anymore Icon_minitimeFri May 17, 2013 7:17 pm

Thank you guys! I will give it a shot!!
Back to top Go down
Sponsored content





mac 11 hex screw won't fit barrel anymore Empty
PostSubject: Re: mac 11 hex screw won't fit barrel anymore   mac 11 hex screw won't fit barrel anymore Icon_minitime

Back to top Go down
 
mac 11 hex screw won't fit barrel anymore
Back to top 
Page 1 of 1
 Similar topics
-
» Nakata luger wont reasembly?
» REMOVING MY MGCMP40 Barrel
» MGC MP40 ... Missing a Screw?
» MGC MP40 Missing a Screw???
» Screw set for C96 (M712) Mauser grips

Permissions in this forum:You cannot reply to topics in this forum
MP40's Modelguns Forum :: Modelgun Problems-
Jump to: